EMF Baseline Readings
Written for the April 1st 2012 S.A. Paranormal Meet-up
Written and researched by
Allen Tiller
of
Eidolon Paranormal
I
am providing here information about two different variations of getting
your baseline readings before you start your investigation, both are
legitimate ways to obtain your readings, however, the first "Positional The baseline" could be considered the more "scientific" approach of the two.
I
may at a later date add more variations and explanations to this page
as we delve further into this topic in future meet-ups - Allen Tiller
Positional baseline
This
is a baseline reading to set a standard for your investigation. You
need two measuring instruments that measure the same parameters (e.g
Magnetism, temperature) and have similar specifications have two
devices of the same model and type, for example, two Mel Meters
“Mel8704r's” that have been properly calibrated.
You
place one of the Mel8704r's at the “location of the haunting” (e.g.
the room where the haunting occurred) and you place the other one in a
location nearby which we call the control location. The two locations
need to be as similar as possible in temperature, lighting etc., The
control location must be a place where there have been no reports of
paranormal phenomena
We can expect that the readings would be similar, or the same, the length of the investigation. Differences that are noted may indicate a
variable related directly to the paranormal phenomena, that may not have been accounted for previously.
This kind of baseline reading allows us to compare the “control
location” with the “location of the haunting” which allows us to see any
differences in readings (e.g. magnetism, temperatures) which may be
related directly to the source of the “paranormal phenomena”. It may
also, allow us an insight into a natural explanation that hasn’t yet been
perceived
You
would expect readings to be similar over the course of the vigil. Any major differences, particularly when something is reported, could be significant. They may indicate a variable related to the reported paranormal event.
Grid Method
This
works best if the location owner will allow you to mark out a grid on
the location floor, but, as this is highly unlikely, it is easier to
have some graph paper and draw a map, allocating a certain amount of
graph squares per each meter, thus creating the grid-squares.
On your map remember to mark all walls, windows, doors, objects (cupboards, fridges etc.)
Now
as one investigator begins to measure each sectioned grid for EMF the
other notes the reading in each individual grid section. (A slight
variation is to allocate each grid a number or letter, then have the
letters written on another page, and write the reading next to the corresponding letter).
If there are odd readings, or “spikes” during this phase, investigate possible causes.
Do this once with the power on.
Then once with the power off (if allowable).
Now
take measurements near all electrical power-points, light fittings and
electrical devices, remember fridge and freezers have motors that turn
on and off and will give out differing readings during the evening, note
if the fridge/freezer's motor is on or off during your measurement
times.
You can now repeat measurements at intervals during the investigation and compare reading levels in your audit.
